Table of Contents
Advertisement
Cleaning the self-cleaning recharger
Beard trimmings may become attached to the cleaning
tray of the self‑cleaning recharger. Follow the steps
below to remove them. We recommend doing this each
time you change the detergent cartridge.
2
2
ES-LA92_CH.indb
26
1. Be sure to remove the
water tank and the
appliance plug from the
self‑cleaning recharger.
•
Be careful not to spill
the cleaning liquid.
2. Gently wipe off any beard
trimmings attached to the
inside of the cleaning tray
with a cloth or tissue
paper dampened with
water.
•
Clean the corners and
uneven parts of the
cleaning tray with a
cotton swab dampened
with water.
•
Do not pull hard on the rubber blade protector at the
bottom of the cleaning tray. The rubber may come off
if you pull hard on it. It is only necessary to pull it up
slightly.
•
Warning
‑ Do not wash or apply water to the
adaptor or self‑cleaning recharger. Failure to
observe this may cause electric shock or result in
short circuits.
When the water does not drain from the
cleaning tray
Beard trimmings may clog
the drain at the bottom of
the cleaning tray.
In this case, you cannot
clean or dry the shaver.
Push the beard trimmings
down through the drain with
a tooth pick etc.
2009/05/22
21:08:19
Advertisement
Table of Contents
