Tufline LR1 Series Operator's Manual

Landscape rakes

Advertisement

Quick Links

O P E R A T O R ' S
Landscape Rakes
LR1-60
LR1-72
LR1-84
LR1 & LR2_14339_07/18
LR1&LR2
M A N U A L
LR2-72
LR2-84
LR2-96
LR2-120

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LR1 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Tufline LR1 Series

  • Page 1 O P E R A T O R ' S M A N U A L Landscape Rakes LR1&LR2 LR1-60 LR2-72 LR1-72 LR2-84 LR1-84 LR2-96 LR2-120 LR1 & LR2_14339_07/18...
  • Page 2: Introduction Ii

    TO THE DEALER: Assembly and proper installation of this product is the responsibility of the Monroe Tufline dealer. Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Owner’s/Operator’s Manual are completed before releasing equipment to the owner.
  • Page 3: Table Of Contents

    TABLE OF CONTENTS INTRODUCTION ..........ii SPECIFICATIONS / GENERAL INFORMATION .
  • Page 4: Specifications / General Information

    SPECIFICATIONS Width Weight Model # LR1-60 348# LR1-72 328# LR1-84 405# Model # WIdth Weight LR2-72 475# LR2-84 525# LR2-96 575# LR2-120 650# GENERAL INFORMATION The purpose of this manual is to assist you The illustrations and data used in this in operating and maintaining your Land manual were current at the time of print- Plane.
  • Page 5: Safety Decals 2

    SAFETY & INSTRUCTIONAL DECALS ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH Replace Decals Immediately If Damaged! Check that all safety decals are installed and in good condition. Replacement Part numbers are listed below.
  • Page 6: Safety Rules

    SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Safety is a primary concern in the design and Wear sturdy, rough-soled work shoes and protec- manufacture of our products. Unfortunately, our tive equipment for eyes, hair, hands, hearing, efforts to provide safe equipment can be wiped out and head;...
  • Page 7 SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! OPERATION • Do not stop, start, or change directions suddenly on slopes. • Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked • Always operate down slopes; never across the and secured.
  • Page 8 SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! MAINTENANCE(cont’d) area while performing adjustments, service, or • When performing maintenance or repairs maintenance. make sure the equipment is in the lowered • Tighten all bolts, nuts, and screws to torque position and properly blacked and secured to chart specifications, page 12.
  • Page 9: Dealer Instructions 6

    DEALER INSTRUCTIONS Instruct customer that service work does not Dealer Checklist require going underneath unit and never to do (Dealer’s Responsibility) Inspect the equipment thoroughly after assem- ____ Complete the Warranty Registration bly to be certain it is set up properly before located on the Frontier website.
  • Page 10 OPERATION levers can cause equipment to drop or rotate Safety is a primary concern in the design and unexpectedly and cause severe injury or death. manufacture of our products. Unfortunately, our efforts to provide safe equipment can be wiped • Service work does not require going under- out by an operator’s single careless act.
  • Page 11: Operation 8

    Connecting Landscape Rakes The landscape rakes compatible with tractors equipped with Category 1, 3-point hitch systems that use side-swing type lower lift arms. The land ANGLE planes will also fit tractors equipped with an To adjust the angle, remove the pivot pin, Ref. 1, Category 1 Quick Hitch system.
  • Page 12: Owner Service

    OWNER SERVICE WARNING WARNING mation. • NEVER GO UNDERNEATH EQUIPMENT. Never place any part of the body underneath • Keep all persons away from operator control equipment or between moveable parts even area while performing adjustments, service, or when the engine has been turned off. Hydraulic maintenance.
  • Page 13: Parts Catalog 10

    *MS = Model Specific Parts Catalog 10...
  • Page 14 12 Parts Catalog 11 Parts Catalog...
  • Page 15: Bolt Size And Bolt Torque Chart 12

    Bolt Size Chart SAE Torque Chart Bolt Size and Bolt Torque Chart 12...
  • Page 16 PART NO. 14339 © 2018 Monroe Tufline Manufacturing, Inc. All Rights Reserved...

Table of Contents