Advertisement
2.
Loosely install the pivot tube bracket onto the
right side
(Figure
5).
3.
Slide the right-hand side of the pivot tube into
the right side pivot tube bracket
4.
Insert the spring rod into the hole in the spring
bracket, and loosely secure it with a locknut (3/8
inch).
Note:
Position the spring rod as shown in
Figure
6.
Figure 6
1. Extension spring
2. Spring rod
3. Locknut (3/8 inch)
5.
Raise the left-hand side of the pivot tube to the
frame and install it with a pivot tube bracket, 2
bolts (3/8 x 3 inch), and 2 locknuts (3/8 inch)
(Figure
5).
6.
Mount the spring bracket to the front frame tube
with a bolt (3/8 x 2-3/4 inch) and a locknut (3/8
inch).
Note:
Position the spring bracket as shown in
Figure
6.
7.
Tighten all fasteners, but do not tighten the
locknut that secure the spring rod at this time.
(Figure
5).
g346051
4. Frame
5. Spring bracket
6. Bolt (3/8 x 2-3/4 inch)
4
Installing the Adjustable
Rod Assembly
Parts needed for this procedure:
1
Adjustable rod assembly
1
Bolt (1/2 x 1-1/2 inches)
2
Locknut (1/2 inch)
Procedure
1.
Position the ball joint of the short end of the
adjustable rod assembly to the right of the
adjustable rod lever on the pivot tube
1. Adjustable rod lever on the
pivot tube
2. Short-end ball joint
3. Adjustable rod
2.
Move the lift handle to the second detent
position from the top.
3.
Place the ball joint on the long end of the
adjustable rod assembly over the stud on the
bottom on the lift handle assembly and loosely
secure it with a locknut (1/2 inch)
Note:
You can move the pivot tube up or down
in its brackets to gain clearance for mounting
the adjustable rod.
4.
Move the lift handle all the way downward to the
bottom detent position.
5.
Move the ball joint on the short end of the
adjustable rod around the adjustable rod lever
5
(Figure
Figure 7
4. Long-end ball joint
5. Lift handle assembly
6. Second detent position
(Figure
7).
g003483
7).
Advertisement
