Advertisement
Note:
Position the saddles as shown in
10.
Figure 10
1. Bolt (5/16 x 1 inch)
2. Saddle
6
Installing a Toolbar
Parts needed for this procedure:
1
Toolbar (sold separately)
Procedure
Important:
If you are installing tool bar 08733
or 08736, skip this procedure and install it using
the instructions provided with that toolbar. Once
installed, go to Installing the Toolbar Lift Pedal in
these instructions.
Note:
If your toolbar comes without the pivot bracket
installed, install it to the fourth tooth from the left as
shown in
Figure
11, and tighten the bolt and nut so that
the bracket and tooth are secure before proceeding.
Figure
g345308
3. Lift arm
4. Locknut (5/16 inch)
1. Toolbar
2. Pivot bracket
1.
Position each end of the attachment tube onto
the saddles.
Note:
The cutting edges of the tines should
point forward.
2.
Move the lift handle to the middle position.
3.
Secure the front of each saddle to the tube
assembly with a bolt (5/16 x 1 inch) and a
locknut (5/16 inch)
1. Saddle
7
Figure 11
3. Fourth tooth
4. Tooth mounting hardware
(Figure
12).
Figure 12
2. Attachment tube
g004101
g003489
Advertisement
