Advertisement
1. Locknut (5/16 inch) (2)
2. Right rear frame tube
3. Detent plate
4. Handle guide
7.
Install the detent plate to the back of the right
rear vertical frame tube with 2 bolts (5/16 x 2-1/4
inch), the 2 washers removed in step 4, and
2 locknuts (5/16 inch). Position the parts as
shown in
Figure
8.
Thread the knob onto the lift handle
9.
Ensure that the lift handle moves the full range
of motion through the detent plate and that it
locks into place at each detent location.
Note:
If the lift handle is too loose or too tight,
tighten or loosen the locknuts on the handle lift
pivot
(Figure
4).
1. Handle lift assembly pivot
10.
Check the clearance between the lift handle
assembly and the hydraulic lines.
Figure 3
5. Scarifier lift handle
6. Knob
7. Washer (2)
8. Bolt (5/16 x 2-1/4 inch) (2)
3.)
(Figure
Figure 4
2. Locknut
Note:
There must be a minimum clearance of
3 mm (1/8 inch) between the hydraulic line and
the lift handle assembly. Gently position the
hydraulic line as required
3
Installing the Pivot Tube
and the Tension Spring
Parts needed for this procedure:
g019398
1
Pivot tube
1
Extension spring
1
Spring rod
2
Pivot tube bracket
4
Bolt (3/8 x 3 inches)
6
Locknut (3/8 inch)
1
Spring bracket
1
Bolt (3/8 x 2-3/4 inches)
Procedure
3).
Note:
If you are installing tool bar 08733 or 08736,
install the pivot tube brackets supplied with those tool
bars instead of the ones supplied with this attachment.
Refer to the installation instructions for 08733 or
08736 for more information.
1.
Connect the extension spring to the spring lever
on the pivot tube and to the spring rod
g003480
1. Locknut (3/8 inch)
2. Pivot tube bracket
3. Bolt (3/8 x 3 inch)
4. Pivot tube
4
(Figure
2).
(Figure
Figure 5
5. Extension spring
6. Spring rod
7. Front of machine
5).
g346050
Advertisement
