Advertisement
7
Installing the Toolbar Lift
Pedal
Parts needed for this procedure:
1
Lever assembly
1
Bolt (5/16 x 2 inches)
3
Locknut (5/16 inch)
1
Pivot tab
1
Toolbar link
1
Carriage bolt (3/8 x 1-1/4 inches)
1
Spacer
1
Washer (1 inch)
1
Locknut (3/8 inch)
1
Pedal lever assembly
2
Retaining ring
1
Washer (7/8 inch)
1
Bolt (5/16 x 1 inch)
1
Eccentric bolt
Procedure
1.
Slide the post on the lever assembly into the
left end of the pivot tube, and secure it with a
bolt (5/16 x 2 inches) and a locknut (5/16 inch)
through the pivot tube
Note:
You may need to thread the bolt through
the pivot tube and the lever assembly.
(Figure
13).
1. Lever assembly
2. Pivot tube
2.
Loosely install the center hole of the pivot tab to
the pivot bracket on the toolbar using a bolt (5/16
x 1 inch) and a locknut (5/16 inch)
1. Pivot tab
2. Pivot bracket
3. Toolbar
3.
Slide the end of the toolbar link over the short
post on the pedal lever assembly, and secure it
with a retaining ring
8
Figure 13
3. Bolt (5/16 x 2 inches)
4. Locknut (5/16 inch)
(Figure
Figure 14
4. Bolt (5/16 x 1 inch)
5. Locknut (5/16 inch)
(Figure
15).
g345309
14).
g004103
Advertisement
