Advertisement
2.
Rotate the eccentric bolt either direction until the
toolbar tines are parallel to the notch in the lift
arm
(Figure 17
and
Important:
The eccentric bolt will not rotate
360 degrees. When it stops, do not attempt
to force it further or you will damage it.
Instead, rotate it back the other direction.
1. Desired position, parallel
to the lift arm notch
3.
Torque the center pivot bolt (item 4 in
to 175 to 225 inch-lb (20 to 25 N⋅m).
4.
Tighten the nut that secures the eccentric bolt
until it is secure, but do not over-tighten it.
5.
Test the operation of the attachment.
10
Leveling the Toolbar
Parts needed for this procedure:
1
Shim (Part No. 110-7379)
1
Shim (Part No. 110-7380)
1
Shim (Part No. 110-7381)
Procedure
Once the toolbar has been installed and the fasteners
are tightened, use the following procedure to verify
that the toolbar teeth are level:
1.
Park the machine on a level surface.
2.
Check the pressure of all tires and ensure
that they are equal. Refer to the Operator's
Manual for more information on checking the
tire pressure.
3.
Lower the toolbar until the teeth just begin to
make contact with the ground.
4.
If the teeth of the toolbar contact the ground
evenly, the toolbar is level.
Figure
21).
Figure 21
2. Notch in the lift arm
Figure
Note:
If the teeth on one side of the toolbar
contacts the ground before the other side, level
the toolbar. Continue leveling by following the
remainder of this procedure.
5.
Measure the gap from the toolbar teeth to the
ground on the side that requires leveling, then
use the following table to determine which shim
to install based on the gap measurement:
Shim pack (Thickness in
inches)
110-7379 (.0747 inches)
110-7381 (1345 inches)
110-7379 and 110-7381
(.2094 inches)
110-7380 (.25 inches)
g003486
110-7379 and 110-7380
(.3247 inches)
6.
Loosen the bolts that secure the pivot tube
bracket to create an opening between the frame
13)
and the pivot tube bracket
1. Shim
2. Pivot tube bracket
Note:
Installing the shim may require that
you remove the lift pedal to access pivot tube
bracket. Refer to Installing the Toolbar Lift Pedal.
7.
Install the shim(s) and tighten all fasteners.
8.
Verify that the toolbar is now level. If not, adjust
it as needed.
11
Change in Tooth height
(inches) on Outside Edge
1/8 inch
1/4 inch
3/8 inch
7/16 inch
9/16 inch
(Figure
22).
Figure 22
3. Bolt
g004794
Advertisement
