Advertisement
Procedure
7
8
9
10
11
1
Preparing for Installation
No Parts Required
Procedure
Note:
If you are installing tool bar 08733 or 08736,
install the pivot tube brackets supplied with those tool
bars instead of the ones supplied with this attachment.
Refer to the installation instructions for 08733 or
08736 for more information.
Note:
When installing a front manual blade in
conjunction with a midmount toolbar system, install
the midmount toolbar system first.
1.
Park the traction unit on a level surface and
engage the parking brake.
2.
Move the throttle switch to the low-idle position,
lower the attachment, and ensure that the
traction is in neutral.
3.
Shut off the engine, remove the key, wait for all
moving parts to stop, and allow all components
to cool.
Description
Lever assembly
Bolt (5/16 x 2 inches)
Locknut (5/16 inch)
Pivot tab
Toolbar link
Carriage bolt (3/8 x 1-1/4 inches)
Spacer
Washer (1 inch)
Locknut (3/8 inch)
Pedal lever assembly
Retaining ring
Washer (7/8 inch)
Bolt (5/16 x 1 inch)
Eccentric bolt
No parts required
No parts required
Shim (Part No. 110-7379)
Shim (Part No. 110-7380)
Shim (Part No. 110-7381)
No parts required
Qty.
1
1
3
1
1
1
1
Install the toolbar lift pedal.
1
1
1
2
1
1
1
Adjust the pivot spring tension and the
–
adjustable rod assembly.
–
Adjust the toolbar transport height.
1
1
Level the toolbar.
1
–
Read and store the documentation.
2
Installing the Scarifier
Lift-handle Assembly
Parts needed for this procedure:
2
Bolt (5/16 x 2-1/4 inches)
2
Nut (5/16 inch)
1
Scarifier lift-handle assembly
2
Bolt (1/2 x 3-1/4 inches)
2
Thin locknut (1/2 inch)
1
Detent plate
1
Knob
Procedure
1.
Lift the rear of the machine onto jack stands and
remove the rear wheels; refer to your machine's
Operator's Manual.
Note:
Place the jack stands under the rear
wheel motor mounts; refer to your machine's
Operator's Manual.
2
Use
Advertisement
