Table of Contents
Advertisement
7. F5M-IQ TOUCHPAD PROGRAMMING
The F5M-IQ system provides access to the following features: display intensity, push-buttons backlight in-
tensity, push-buttons ON light intensity through touchpad programming
To make settings adjustments follow these steps:
Step 1:
Press and hold down SW8 and SW10.
Step 2:
Enter "BACKLIGHT" setup.
To adjust press SW9 to decrease, SW10 to increase.
Press SW8 to save and move to next function.
Step 3:
Enter "KEYBRIGHT" setup.
To adjust press SW9 to decrease, SW10 to increase.
Press SW8 to save and move to next function.
Step 4:
Enter "DISPBRIGHT" setup.
To adjust press SW9 to decrease, SW10 to increase.
Press SW8 to save and exit programming
8. F5M-IQ VOLTAGE CALIBRATION
The F5M-IQ system provides a continuous battery voltage reading on the touchpad's display. After a set-
up update, the display will show "Voltage 0V" even though the voltage input is connected to the battery.
The system needs a voltage reading calibration.
To make adjustments follow these steps:
Step 1:
Using a multi-meter measure the input voltage in the IQ system.
Step 2:
Press and hold down SW8 and SW10.
Step 3:
Enter "BACKLIGHT" setup.
Continue to hold down SW8 and release SW10.
Step 4:
Enter "RELAYBOX INPUTS" status. Release SW8.
Press SW8 to save and move to next step.
Step 5:
Enter "LIGHTBAR INPUTS" status.
Press SW8 to save and move to next step.
Step 6:
Enter "CALIBRATION VOLTAGE".
Adjust the voltage on the display to match the voltage measured
in Step 1. Use SW9 to increase and SW10 to decrease value.
Press SW8 to save and exit voltage calibration.
8
July 31, 2019
Advertisement
Table of Contents
