4-Installation - D&R ELECTRONICS F5M-IQ Installation Manual

4. Installation
CONNECTOR #1
PIN 1 — Connect a BLACK 10 AWG wire to battery GROUND.
PIN 2 — Connect a RED 10 AWG wire to the POSITIVE side of the battery, using a 60A breaker.
PIN 3 — Connect a RED 10 AWG wire to the POSITIVE side of the battery, using the same 60A breaker
as PIN 2.
PIN 4 — OUTPUT 1, 20A MAX
NOTE: If this pin is used then OUTPUT 1 on CONNECTOR 2, PIN 2 cannot be used.
CONNECTOR #2
PIN 1 — Connect a 16 AWG wire to +12V IGNITION feed. This feed is used to turn ON the system.
PIN 2 — OUTPUT 1, 10A MAX
NOTE: If this pin is used then OUTPUT 1 on CONNECTOR 1, PIN 4 cannot be used.
PIN 3 — OUTPUT 2, 10A MAX
PIN 4 — OUTPUT 3, 10A MAX
PIN 5 — OUTPUT 4, 10A MAX
PIN 6 — OUTPUT 5, 10A MAX
PIN 7 — OUTPUT 6, 10A MAX
PIN 8 — OUTPUT 7, 10A MAX
PIN 9 — OUTPUT 8, 10A MAX
CONNECTOR #3
PIN 1 — OUTPUT 9, 2A MAX
PIN 2 — OUTPUT 10, 2A MAX
PIN 3 — OUTPUT 11, 2A MAX
PIN 4 — OUTPUT 12, 2A MAX
PIN 5 — OUTPUT 13, 2A MAX
PIN 6 — OUTPUT 14, 2A MAX
PIN 7 — OUTPUT 15, 2A MAX
PIN 8 — OUTPUT 16, 2A MAX
PIN 9 — OUTPUT 17, 2A MAX
PIN 10 — OUTPUT 18, 2A MAX
PIN 11 — OUTPUT 19, 2A MAX
PIN 12 — OUTPUT 20, 2A MAX
CONNECTOR #4
CONNECTOR #5
NOTE: The expanders are optional modules in case extra outputs are needed. There are 2
different expander modules:
IQEXP-LC
IQEXP-HC
- expander control cable OUTPUT 21 to 30
- expander control cable OUTPUT 31 to 40
10 OUTPUTS @ 2A each
4 OUTPUTS @ 20A each & 6 OUTPUTS @ 10A each
5
July 31, 2019