SMC Networks ZL6 Series Operation Manual page 13

No. Terms
I Indication accuracy
Insulation resistance
Indication resolution
Indication LED
Indication unit
K
Key lock function
M
Manual set up
Max. applied voltage
Max. (Min) load impedance
Measurement mode
Min. setting unit
N
Normal output
NPN (open collector) (output)
O
Output configuration
Output mode
Shows the deviation between displayed pressure value and the true pressure.
Insulation resistance of the product.
The resistance between the electrical circuit and the case.
How fine the rated pressure range can be segmented. (Example: If a product
for 0 to 1 MPa can indicate pressure by 0.001 MPa, the indication resolution is
1/1000.)
The LED that turns on when the switch output is ON.
The unit of pressure used in the display.
Function that prevents changes to the settings of the Pressure switch (disables
button operation).
Manual pressure setup without using auto preset.
This term is used to distinguish between manual and auto preset pressure
setup.
The maximum value of applied voltage available to the output line of the NPN
output.
The maximum (minimum) load (resistance value and impedance) which can be
connected to the output (output line) of the analog current output.
The condition in which the pressure is being detected and indicated and switch
operation is enabled.
Refer to "digit".
One of the switch output types. In hysteresis mode the switch output is turned
ON when pressure equal to or greater than the switch output set value is
detected.
ist of output modes
Refer to "L
The switch that uses the NPN transistor for output.
The operation principle of the switch output.
ist of output modes
Refer to "L
Either hysteresis mode can be selected.
-12-
Meaning
" on page 24)
" on page 24 for the operation status.
NO.ZL3-OM00701-A