Dmx Mode - EuroLite Audience Blinder 4x60W LED COB RGB User Manual

Master/Slave Mode
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear of the Audience Blinder 4x60W LED COB RGB you can find an XLR-jack (DMX Out) and an
XLR-plug (DMX In), which can be used for connecting several devices.
Choose the device which is to control the spotlights. Set the desired master mode on the master device. This
device then works as master device and controls all other slave devices, which are to be connected to the
master device via a balanced microphone lead. Connect the DMX out connectors with the DMX input plug of
the next device.
Set the slave mode on every slave device.
Press the MODE button to select the SLAVE MODE. The devices set in this manner can now be controlled
by the master unit.
Setting dimmer speed (step response)
Press the MODE button until the display shows DIMMER RESPON.
Press the ENTER button.
You can select the dimmer speed: 01 (response characteristics LEDs) or 02 (response characteristics of
halogen lamps) via the UP or DOWN button.
Confirm your choice by pressing ENTER.
Invert function
In this mode, you can change the chaser direction, from left to right or from right to left.
Press the MODE button to select the FLOW INVERT function.
Press the ENTER button.
Press the UP or DOWN button to select ON or OFF. This will change the flow direction.
Please press the ENTER button to confirm.

DMX MODE

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the Audience Blinder 4x60W LED COB RGB will respond to the controller.
Addressing
Press the MODE button until the display shows DMX MODE.
Press the ENTER button and the display shows: Addr: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
Choosing a DMX Channel Mode
The device has 4 DMX channel modes. The Control Board allows you, as described above, to assign the
DMX-Mode.
24/28 00072234.DOC, Version 1.0