Dmx-512 Connection / Connection Between Fixtures; Operation - EuroLite Audience Blinder 4x60W LED COB RGB User Manual

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and 3-pin or 5-pin XLR-plugs and connectors in order to connect the controller with
the device or one device with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120
between Signal (–) and Signal (+) in the DMX-output of the last fixture.

OPERATION

After you connected the Audience Blinder 4x60W LED COB RGB to the mains, it starts running.
The LCD display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in Stand Alone mode via LCD display with
operating buttons or in DMX-controlled mode via a lighting controller.
- STAND ALONE-MODE
Solid colors/Internal programs
Auto Mode
Sound Mode
Master/Slave Mode
- DMX MODE
Setting dimmer speed (step response)
Invert function
the fixtures will not work at all, or will not work properly.
22/28
resistor
00072234.DOC, Version 1.0