Front Panel; Rear Panel - Samson DA40 Owner's Manual

Front Panel

1
1. Antenna Input Connectors - Connect a pair of tuned coaxial antennas to these BNC jacks.
These antenna outputs are phantom powered, so care should be taken not to short them.
2. POWER Switch - Press and hold this to power the DA40 on or off.
3. Power Indicator - This LED lights whenever the DA40 is powered on.

Rear Panel

4. DC Input - Connect the supplied power adapter here, using the strain relief as shown in the
illustration below. WARNING: Do not substitute any other kind of power adapter. Doing so
can cause severe damage to the DA40 and will void your warranty.
5. Antenna Output (Distributor A) - Use these BNC jacks to connect each of these antenna
outputs to the Antenna A input of the associated receiver.
6. Antenna Output (Distributor B) - Use these BNC jacks to connect each of the antenna out-
puts to the Antenna B input of the associated receiver.
7. DC Output jacks - Use these four 15V DC 800mA outputs to power the wireless receivers.
4
3
5
6
Using the strain relief: Gather up a loop of wire and
pass it through the strain relief, then pass the adapter
plug through the loop in order to create a knot.
2 1
7
4