Electric airless sprayers for portable airless spraying of architectural coatings and paints - 3300 psi (227 bar, 22.7 mpa) maximum working pressure (37 pages)
Electric airless sprayers, for professional use only, not approved for use in explosive atmospheres or hazardous locations, for portable airless spraying of architectural paints and coatings, 3300 psi 228 bar, 22.8 mpa maximum working pressure (88 pages)
Electric texture sprayer for water-based materials only maximum working air pressure: 45 psi (3.1 bar) maximum working fluid pressure: 100 psi (6.9 bar) (37 pages)
Page 1
Fail- ure to lubricate the seal will result in wiper seal dam- age. Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 Copyright 2002, Graco Inc. is registered to I.S. EN ISO 9001 Portions copyright ENDISYS, used with permission.
Read all instruction manuals, tags, and labels before operating the equipment. • Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor. • Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
Scope Scope The Retrofit Kit for ram plates with inflatable wipers can • Adjustable wrench be field installed in less than one hour. Tools required include: • Electric drill with 1/8” drill bit • Standard blade screw driver The Retrofit Kit assembly consists of the parts shown in .
Relieve the pressure (page 9), and remove air supply to unit prior to installing this kit. 3. Remove air tube elbow. See F . 2 for steps 1-4. 4. Remove tubing connections from bottom of actuator valve. Step Step Step Step . 2. Standard Graco Ram Control 309549B...
Page 6
5. Remove 3 legend plates from bracket (pry off with 7. Remove plug from bottom of air regulator. Install screw driver). supplied air tube connector (1/8 npt(m) x 1/4” tube O.D.). Step Step Step . 3. Standard Graco Ram Control 309549B...
Page 7
Installation See F . 4 for steps 8-11. 8. To remount existing ram air actuator, align bottom 10. To mount the new kit, align the top holes of the actu- two holes of actuator with top two holes of mounting ator with the bottom holes of the mounting plate.
Page 8
Installation See F . 5 for steps 12-14. 12. Cut 1/4” tubing (supplied with kit) to length and 14. Connect 1/4” tubing from wiper air control outlet to install between the tube connector at ram regulator the ram plate wiper. When cutting tubing to length, and wiper air control inlet.
Operation Operation Your new sanitary ram plate offers greater versatility and Sequence of Operation value-added features over conventional versions: • When deflated, the seal retracts inside the outer Initial Conditions: diameter of the plate weldment. 1. The ram is fully raised. •...
Cleaning Cleaning Flush the unit before taking it apart for cleaning. Flush 2. On the side opposite the stem and starting with the the system with an over-sized container of cleaning top edge, peel the seal downward. The bottom side solution around the ram plate.
Page 11
Cleaning Install the Inflatable Seal 2. Continue sliding the top edge of the seal over the lower edge of the plate. Be sure to maintain the seal stem position relative to the plate. The seal is Liberally lubricate the ram plate channel and seals with designed to stretch a small amount to fit snugly sanitary grease before reassembly, checking that the inside the plate groove.
Graco distributor to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.