Advertisement
See F
. 4 for steps 8-11.
IG
8. To remount existing ram air actuator, align bottom
two holes of actuator with top two holes of mounting
plate. Use one screw and nut to anchor to the plate.
9. Drill holes through the mounting plate by using the
top two holes of the actuator as a guide. Secure
actuator to plate with remaining screws and nuts.
F
. 4. New Control Panel (with inflatable wiper regulation)
IG
309549B
Step
10
10. To mount the new kit, align the top holes of the actu-
ator with the bottom holes of the mounting plate.
Use one screw and nut (provided with kit) to anchor
to the plate.
11. Drill two holes through the mounting plate by using
the bottom two holes of the actuator as a guide.
Secure actuator to plate with remaining screws and
nuts (supplied).
Step
9
Step
8
Step
11
Installation
TI4013a
7
Advertisement
