CLUTCH LEVER
Make sure the clutch lever position is correct.
The standard setting of this motorcycle is as indicated
in the table below.
Standard setting
A: Adjuster
THROTTLE CABLE
This motorcycle has a twin throttle cable system.
Cable A is for pulling cable and cable B is for return-
ing.
Check the throttle cable play at the throttle grip.
Throttle cable play: 2.0–4.0 mm (0.08–0.16 in)
If adjustment is necessary, carry out the procedure
below:
1. Loosen the throttle cable adjuster lock nut C.
2. Turn the adjuster D in or out until the correct play is
obtained.
3. Tighten the lock nut C while holding the adjuster D.
4. Place the rubber boot E.
After the adjustment is completed, check that
handlebar movement does not raise the engine
idle speed and that the throttle grip returns
smoothly and automatically.
20
Position 2