Toro Groundsmaster 3500-D Operator's Manual page 20

Mow/Transport Slide
Using your heel, move the mow/transport slide to the
left to transport, and to the right to mow
Note:
The cutting units operate only in the mow
position.
Important:
The mow speed is set at the factory
to 9.7 km/h (6 mph). You can increase or decrease
the mow speed by adjusting the speed-stop screw
(Figure 24).
Figure 24
1. Speed-stop screw
Indicator Slot
The indicator slot in the operator platform indicates
when the cutting units are in the center position
(Figure 21).
Throttle
Move the throttle forward to increase the engine
speed and rearward to decrease the engine speed
(Figure 22).
Cutting-Unit-Drive Switch
The cutting-unit-drive switch has 2 positions: E
and D . The rocker switch operates a
ISENGAGE
solenoid valve on the valve bank to drive the cutting
units (Figure 22).
Cutting-Unit Shift Lever
To lower the cutting units to the ground, move the
cutting-unit shift lever forward. To raise the cutting
units, pull the shift lever rearward to the R
(Figure 22).
Note:
The cutting units do not drop unless the engine
is running.
Move the lever to the right or left to move the cutting
units in the same direction.
Note:
Do this only when the cutting units are raised or
if they are on the ground and the machine is moving.
Note:
forward position while you are lowering the cutting
units.
(Figure 21).
Alternator Light
The alternator light should be off when the engine is
running
Note:
it as necessary.
g031596
NGAGE
position
AISE
20
The lever does not need to be held in the
(Figure 22).
If it is on, check the charging system and repair