Ryobi RG-2600I Owner's Operating Manual page 3

Inverter generator
Table of Contents

Advertisement

IMPORTANT SAFETY INSTRUCTIONS
Do not operate generator when you are tired or
under the influence of drugs, alcohol, or
medication.
The electrical output load must not exceed the
maximum load stated on the rating plate.
Exceeding the rated load will damage the unit or
shorten its life and will invalidate the guarantee.
The engine must not be run at speeds that exceed
the maximum stated on the rating plate.
Operating an engine at excessive speeds
increases the hazard of personal injury.
Do not tamper with components, which may
increase or decrease the governed speed.
Mains extension leads, mains supply leads, and all
electrical equipment must be in good working
condition.
Never operate electrical equipment with damaged
or defective mains supply leads.
Keep the area around the generator clear of
obstructions at all times. Never locate the
generator against a building or near a canvas or
plastic structure i.e.Tents etc.
Always use the correct fuel mix as stated in the
user manual and on the rating plate.
To reduce the risk of fire and burn injury, handle
fuel with care. It is highly flammable.
Do not smoke while handling fuel.
Store fuel in a container approved for gasoline.
To prevent fire, always stop the engine and allow to
cool for five minutes before refueling and never
over fill the fuel tank.
Loosen fuel cap slowly to release pressure and to
keep fuel from escaping around the cap.
Tighten the fuel cap securely after refueling.
Wipe spilled fuel from the unit.
Never attempt to burn off spilled fuel under any
circumstances.
Always clean up spilt fuel immediately using sand.
Do not use the generator in or near an explosive
atmosphere.
To prevent an electric shock, never operate the
machine in rain, snow or touch with wet hands.
Check the fuel system periodically for leaks. Seals
and hoses should be checked for signs of
deterioration or chafing. Check for loose or missing
clamps damaged fuel tank or filler cap. All defects
should be corrected before further use.
Always allow the generator to reach full operating
speed before connecting any electrical load.
Always disconnect the electrical load before
switching the generator off.
To prevent surging that may possibly damage
electrical equipment, do not allow engine to run out
of fuel while electrical loads are connected.
Before transporting the generator in a vehicle, drain
all fuel to prevent spillage.
To prevent an electric shock and fire, never
connect an electrical load with the electrical output
switched on.
Do not connect the generator to any other electrical
source.
Before storing, allow the engine to cool for 30
minutes and drain fuel from the unit.
Do not store the generator in rain, snow, or wet
weather.
Store the generator in a well-ventilated area with
the fuel tank empty. Fuel should not be stored near
the generator.
Empty fuel tank, place the engine switch/fuel
valve/choke lever in the OFF position, and restrain
the unit from moving before transporting in a
vehicle.
Provide a plastic sheet or absorbent pad below the
generator to catch any drips of fuel or lubricant
when transporting.
Generators vibrate in normal use. During and after
the use of the generator, inspect the generator as
well as extension cords and power supply cords
connected to it for damage resulting from vibration.
Have damaged items repaired or replaced as
necessary. Do not use plugs or cords that show
signs of damage such as broken or cracked
insulation or damaged blades.
3

Advertisement

Table of Contents
loading

Table of Contents