Manually Starting The Data Collection Tool - Texas Instruments TI-NSPIRE Software Manual

Manually starting the Data Collection tool

When you choose to add the Data Collection tool to a Graphs &
Geometry application page, it is strongly recommended that you also
add Lists & Spreadsheet to the page as well. This is not required, but if
you want to store data from multiple experiments, you will need the Lists
& Spreadsheet application on the page.
When you add the Data Collection tool, it attempts to configure itself to
the first available sensor. Any sensor that is already being controlled by
another Data Collection tool is considered unavailable. To make an
unavailable sensor available again, close its Data Collection tool.
To set up a page for Data Collection:
1. Add a new page to your current document or open a new document.
Apply a new page layout template using the
define two work areas.
2. Add Graphs & Geometry to one area of the new page, and add Lists
& Spreadsheet to the second area.
3. Add the Data Collection tool to the page containing Graphs &
Geometry. To do this, select the Data Collection tool from the Tools
menu.
Data Collection
button to
345