Error Message - Panasonic FZ-M1 Series Operating Instructions - Reference Manual

Error Message

Follow the instructions below when an error message appears. If the problem persists or if the error message is not shown here, contact Panasonic Tech-
nical Support.
Error Message
Bad System An error has occurred in the memory of system settings. This occurs when the memory content is changed by an unexpected pro-
CMOS gram operation, etc.
Start the Setup Utility and return the settings to the default values, and then change the settings as necessary.
System CMOS
If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical Support.
Checksum Error
Invalid Year. Sys- The date and time settings are not correct.
tem date restored
Start the Setup Utility and set the correct date and time.
to 01/01/20XX
If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical Support.
Write down the error details and start the Setup Utility.
Press F2 for
Change the settings if necessary.
Setup
Warming up the The computer is warming up before start up. Wait for the computer to start up (takes up to 30 minutes). If, "Cannot warm up the
system (up to 30 system" is displayed, the computer failed to warm up and does not start. In this case, turn off the computer, leave it in an envir-
minutes) onment of 5 °C {41 °F} or higher temperature for about an hour, and then turn on the power once more.
If a device is connected to the USB port, disconnect the device, or set [USB Port] to [Disabled] in the [Advanced] menu of
Remove disks or
the Setup Utility.
other media.
If the problem persists after removing the disk, it may be a flash memory failure. Contact Panasonic Technical Support.
Press any key to
restart
Use the specified AC adaptor.
Please use the
recommended
AC adaptor
Solution
- 128 -