Num'axes Canifugue FUG1030 User Manual page 29

ADVICE AND INFORMATION
Getting the best results

ØAdjusting and positioning the collar:
It is very important that the collar is properly adjusted to your dog's neck. Its position enables
straying to be detected and stimulations to be transmitted.
The position of the collar around the neck of the dog should always be in the following way: the
CANIFUGUE label is visible and is not in contact with the breast of the dog.
To achieve best results from your appliance, you must ensure good contact between the collar
and your dog's skin by careful adjustment of the strap: if the collar is too loose, it will not work
properly, if it is too tight your dog may have trouble breathing.
If necessary, replace the short contact points with long ones (see section on replacing the
contact points).
ØCheck the battery of the collar:
Make sure the battery is working properly: its condition affects the proper functioning of the
collar. At temperatures below 0°C, the battery is less effective than at room temperature.
ØCheck tightness of contact points:
Before each use, make sure both contact points are properly tightened on the unit.
Essential requirements:
- Never lay the antenna wire near an electrical cable, telephone cable, television or satellite
aerial wire.
- During thunderstorms, disconnect the transmitter power unit from the mains and
especially unplug the antenna wire connector.

Cautions for use
• Prevent any water from infiltrating the collar when it is open (especially when changing
the battery), the transmitter unit or the power unit.
• Remove the battery from its housing if you are not using the appliance for 3 months or more.
• Never leave an old battery in the collar: it may leak and damage your CANIFUGUE.
Canifugue FUG1030 Guide_Indice I.indd 29
Gb - 29
28/06/2018 14:49