Num'axes Canifugue FUG1030 User Manual page 23

AUTOMATIC SYSTEM
As soon as the animal wearing the
collar enters the protected area,
he is warned by a beep sound. If he
continues to move forward, towards
the perimeter wire, he receives
stimulations.
The wire is placed on the ground,
buried or raised on an existing fence.
For the system to function, the wire
must form an uninterrupted loop.
Both wires must be spaced 2 meters
apart.
Switching On/Off

Switching On:
Ø
• The transmitter
Connect the transmitter to the power supply by plugging the AC adapter into the power jack on
the transmitter and into a wall outlet. A green indicator light comes on, the transmitter is On.
NOTE: Do not connect the transmitter to the power supply before connecting the antenna
wire to the antenna socket. The wire break alarm would alert you to a connection default
(cf. § Breakage of antenna wire).
• The collar
Fitting the battery: Unscrew the 4 screws on the battery cover (cf. Diagram No. 2), insert
the battery (CR2) in the position indicated on the battery housing. A beep sound indicates
that the collar is switched on.
Check that the seal is in place in the groove of the battery cover.
Before re-tightening the 4 screws, force the strap against the battery cover by pulling it.
Using a screwdriver, moderately tighten the 4 screws.
Switching Off:
Ø
If the collar is not to be used for a long period, the battery should be removed from its
housing. If you want to take your dog off the property, you are advised to remove the
receiver collar. You can also deactivate the transmitter by disconnecting it from the power
supply (the green indicator light goes out).
Canifugue FUG1030 Guide_Indice I.indd 23
Antenna wire
Warning
By twisting the outward strand with the inward
beep area
strand, wave emission is blocked and the animal
can move freely within this zone.
Stimulation
area
Gb - 23
Diagram No. 4:
sample installation
2 m between
both wires
Transmitter unit
Twisted wire
28/06/2018 14:49