Operating Sequence - Electrolux EDV6552 User Manual

8 www.electrolux.com

3.2 Operating Sequence

Step 1
Do not load clothes or other articles which
are dripping wet or have sand and grit on
them into your dryer.
Step 2
Step 3
Press then release the On/Off button on the control
panel. You are now ready to select your drying
Program.
You can use your dryer 2 ways
Auto sensing
Manual timing program
1. Select Drying Program or Set Drying Time
Drying Program
This mode gives you the
option of selecting different
drying levels.
Press " " button or "
to select either "Extra Dry",
"Normal Dry", "Iron Dry" for full
load and "Fast 40", "Delicate",
"Refresh" for smaller load.
Press door
safety switch
button.
" button
See program table guides for load size info.
To obtain the best drying results with
small loads it is recommended to use
"Time drying" program.
Do not select the "Extra Dry" option for
delicates fabric such polyester as
shrinking may occur.
Time drying
This option allows you to set
the program duration.
Press the " " button or
" " button to select either
90, 60 and 30 min.
2. Select Option
Press the "Option" button to select either
Boost or Low Heat from the option
program.
Refer to the table below for option setting
recommendations.
Option
Boost
For drying delicates and
synthetics at lower heat for
maximum care of the fabrics. The
Low Heat
Low Heat setting will cause the
heater to cycle on for shorter time
than the Boost setting.
This setting does not heat. ONLY
circulate the air in the dryer to
Airing
shake out dust and refresh
clothes.
"Airing" is NOT available in Drying program.
3. Now press Start/Pause button to start the
Dryer.