Advertisement
The device is configured with one programming button and indicator, as described below.
Note: All operation and settings described as below should be carried out when the device
is running normally.
1.1. Switch Power-on to Quick Start
Connect the device to power supply, then it starts
running normally.
1.2. Test Motor Travel
Reconnect the device to power supply. When it restarts,
pull the curtain cloth gently towards any direction.
1.3. Control Curtain Cloth
Function
Open / close / stop /
open or close
at specific percentage
Touch start
Obstruction detection
Operation
Operation
Users can achieve these remote control through smart panels, re-
mote controllers, mobile APP.
The device supports "Touch Start" by default, which can be enabled or disa-
bled through commissioning software or the remote controller used.
"Touch Start" enabled: When users gently pull the curtain cloth, curtain motor
•
will be activated to work and automatically travel towards that pulling direc-
tion.
"Touch Start" disabled: It requires users to manually operate the curtain cloth.
•
When curtain cloth or motor encounters obstacles, in order to avoid dam-
age to the motor or obstacles, the motor will automatically stop running
then modify its travel limit.
Tips: If users need to adjust the motor travel limit, please remove those ob-
stacles then erase travel limit (see Section 2.4. Erase Travel Limit). After-
wards, users can proceed re-setting and testing motor travel.
Status of Indicator
Red light is on for 10s then off.
Status of Motor
Curtain motor will be activated to
work and automatically complete
the pre-set travel.
Operation
8
Advertisement
