Advertisement
Danger：
Please do not privately disassemble or replace any parts of the product. Otherwise, it
•
may cause mechanical fault, electric shock, fire or personal injuries.
Warning：
The installation and testing for the product must be carried out by HDL Automation Co.,
•
Ltd. (hereinafter referred to as HDL) or its appointed service agencies. The electric con-
struction shall comply with local laws and safety regulations.
HDL will not be responsible for any consequence caused by the inexpert or faulty instal-
•
lation and wiring methods, which are not in accordance with the instructions contained
in this datasheet.
Please contact HDL after-sales departments or our designated service agencies for your
•
maintenance service. Product failures caused by private disassembly are not subject to
the warranty.
Caution：
Before performing any installation or disassembly procedures, any maintenance or
•
cleaning procedures on the device, it is crucial to disconnect the device from all voltage
sources. This step is necessary to ensure the safety of the technician and prevent any
potential damage to the device.
Do not use corrosive liquid to wipe the device body, especially the interface, so to avoid
•
damage to the device.
Do not wipe the device with a damp cloth.
•
Prior to performing maintenance or cleaning on the device, disconnect the device from
•
all voltage sources, to avoid electric leakage and electric shock.
Kindly take note that the installation of the aforementioned device is recommended to
•
be conducted in an indoor environment, with due consideration given to the avoidance
of exposure to external factors such as humidity and high temperatures.
Buspro cable: CAT5E or HDL Buspro cable
•
For Buspro connection, a hand-in-hand connection is recommended.
•
After all of the cables are terminated, check for correct and good terminations.
•
Kindly take note that the installation of the aforementioned device is recommended to
•
be conducted in an indoor environment.
It is strictly forbidden to apply any extra items whose weight exceed the motor or guide
•
rail maximum load-bearing to the curtain track; DO NOT climb the curtain.
When installing the motor onto the guide rail, be sure to check if the motor has been
•
tightly attached in place. Otherwise, it will cause the motor to fall, resulting in product
damage or personal injury.
5
Advertisement
