Advertisement
There are three options for users to proceed advanced settings for curtain motor. In this sec-
tion, it gives information about part of the settings rather than all.
Commissioning software: HDL Studio is the software applicable for users to proceed ad-
•
vanced settings for curtain motor, which is highly recommended.
Programming button: It can be used for motor rotation setting, restore factory setting,
•
firmware updating, as well as erasing motor travel.
Remote controller: The device is compatible with remote controllers which support
•
learning codes (see Section 2.7. Learning Codes in Remote Controller).
2.1. Position Device
Operation
Position the device through
commissioning software.
2.2. Modify Device ID
Function
On-line modify
device ID
Manually modify
device ID
2.3. Set Motor Rotation
Tips: Motor rotation can be set by commissioning software or programming button. In this
section, it only gives information about the latter.
Operation
Step 1: Short press pro-
gramming button once
Step 2: Short press program-
ming button once again.
Step 3: Long press pro-
gramming button for 3s.
Step 4: Long press pro-
gramming button for 3s
again.
Status of Indicator
Red light flashes.
Operation
Modify device ID through
commissioning software.
Long press programming button
for 3s, then immediately
release until the indicator is red.
Next, modify device ID through
commissioning software.
Status of Indicator
Red light flashes
quickly.
Red light flashes
slowly.
Red light is on.
Red light flashes
then off.
Status of Motor
Status of indicator and
Rotate 3 times.
Status of
Status of
Indicator
Motor
/
Red light is
on.
Status of Motor
/
/
/
After successfully
set, the motor ro-
tates once.
Remark
motor last for 10s.
Remark
/
If no operation
within 15s, it
/
will exit setting
automatically.
Remark
If no operation on
programming
button within 15s, it
will exit setting au-
tomatically.
9
Advertisement
