Advertisement
Warning: Before performing any installation procedures on the device, it is crucial to dis-
connect the device from all voltage sources. This step is necessary to ensure the safety of
the technician and prevent any potential damage to the device.
Tips: The device should be mounted onto the guide rail. Thus, please make sure the guide
rail has been installed properly.
Step 1. Pull the lock bar out, then slide it in the direction indicated by arrow 1.
Step 2. Insert the motor shaft to the guide rail.
Step 3. Make sure the motor is tightly attached with the guide rail, then slide the lock bar
back in the direction indicated by arrow 3. In this way, the motor can be locked.
Note: After installation, check for correct and good terminations. Before powering on,
please ensure the device is completely mounted onto the guide rail.
7
Advertisement
