Set Space And Address - ETC Echoflex Elaho Dual Tech Wall-mount Vacancy Sensor Installation Manual

Echoflex Installation Guide
Dual Tech Wall-mount Vacancy Sensor
Settings
The Elaho Dual Tech Wall-mount Vacancy
Sensor participates in an Elaho control
system using the configured Space and
Address, which are selectable using the
rotary switches on the sensor electronics
located behind the removable cover.
DIP switches, also located on the sensor
electronics, set the sensor functionality.
Note:
mode, DIP switch 2 set to On, all other DIP switch settings are
ignored.
Note:
LEDs, are not used and have no functionality on the Dual Tech
Wall-mount Vacancy Sensor.

Set Space and Address

Two rotary switches on the sensor electronics provide for Space and
Address assignment for the sensor. By default, these switches are set to
Space 1, Address 1. Commands are shared by all devices within a given
space.
1. Set the Space rotary switch to the desired number (1 through 16)
for the space you want the sensor to control.
2. Set the Address rotary switch to desired address (1 through 16) for
the sensor identification in the selected space.
Note:
Dual Tech Wall-mount Vacancy Sensor
When the sensor is placed into Custom configuration
The [MODE] and Auxiliary [A] buttons, and their related
Do not duplicate a device Address within the same Space.
Page 6 of 12
MODE AUX
Echoflex