Jøtul F 171 ZENSORIC Operating Instructions Manual page 22

INSTRUCTIONS FOR USE
ZENSORIC SIGNAL GUIDE
1 green blink = air damper test OK
1 green blink repeated every 8 seconds = insert wood
2 blue blink repeated every 8 seconds = recharge ba ery
1 red blink = air damper fault
2 red blink = ba ery level low, Zensoric switches off
3 red blink = temperature gauge fault (See page 38 for
replacing temperature gauge)
When charging:
Con nuous red = charging
LED goes out = fully charged
No blinking at fi rst opening of cold stove = fault on door
sensor (see page: 40 for switching the door sensor)
In case of error - contact the dealer of the stove
RESET ZENSORIC
The reset func on is done by connec ng the supplied
USB-C charger plug at the bo om of the side of the stove
and the 5V power supply in the socket.
Next, unplug a er 30 sec. and open the door
and the Zensoric resets
SETTINGS FOR NORMAL
LOAD: 25% 75%
Ash container
Air control
bu on/LED
indicator
Baffl e plates
Ter ary holes
22
Charging input