Is The Blade Tip Cap Of The Auto Blade Loose; Is The Blade Worn, Or Is The Cutting Tip Broken; Is The Blade Depth Too Small, Or Is The Force Set Too Low - Silhouette portait4 User Manual

Is the blade tip cap of the Auto Blade loose?

• If the blade tip cap of the Auto Blade is loose, use the hand-held blade adjuster to retighten it.
Tighten
Loosen

Is the blade worn, or is the cutting tip broken?

• Replace it with a new Auto Blade.
• When the blade wears out, the media that could be cut until now may suddenly no longer be cut.
As a guideline, the service life is about 4 km for vinyl chloride media (cutting film) and about 2 km for paper
media, such as drawing paper, postcards, and Kent paper.

Is the blade depth too small, or is the force set too low?

• Gradually increase the blade depth and force on Silhouette Studio and perform a test cut.
Blade tip cap
Set the Auto Blade by aligning the
concave part of the Auto Blade
tip cap with the hand-held blade
adjuster.
Hand-held blade adjuster
Force setting
Blade Depth setting
Test cut
To avoid bodily injury, handle blades with care.
04 Troubleshooting
Note
56