Auto Cross-Cutting - Silhouette portait4 User Manual

Auto cross-cutting

If you use the auto cross-cutting function, after cutting the design, the specified line on the media is
automatically cut, and the design is separated from the media on the cutting machine.
This function can be used if the following three conditions are met.
The media is either vinyl, iron-print sheet, or using user-defined cutting conditions.
•
The machine is set not to use the mat.
•
The Auto Blade is set.
•
Operation method
1
From the "Panel" menu, select the "Page Setup" panel.
2 Set "Portrait4" for "Machine", "Manual" for "Feed Type", and "None" for "Cutting Mat".
3 Press the "SEND" tab to open the send screen.
4
Set "Vinyl" or "Iron-print sheet" as the cutting condition, or use user-defined cutting conditions.
5
Press the "MORE" button.
6
Select the "Cut" tab.
7
Select the "Auto Cross-Cutting" check box.
8
Set the "Cutting Position", save the setting, and close the screen.
03 About the Silhouette Studio Screen
Note
50