Table of Contents
Advertisement
4
Specify an action such as "Cut" or "Sketch" from the Action pull-down list.
5
Specify the tool to use in the Tool pull-down list.
6
If you want to manually set the cutting conditions, set the blade depth, speed, force, and passes.
First, set the speed to slow and the force to low, and if it is not enough, gradually increase the setting.
(1) Blade Depth:
(2) Speed:
(3) Force:
(4) Passes:
Guideline for blade depth and media materials
Blade depth
1
2 to 3
4 to 6
7 to 10
Auto Blade indicator scale
Check the Auto Blade indicator scale from the front for the actual blade depth.
Since the display surface is curved, it may not be possible to check the correct value if viewed from an angle.
Auto Blade
Force setting
Passes setting
Speed (cutting speed) setting
Blade Depth setting
Automatically protrudes the blade by the amount specified at the time of cutting.
(Only for Auto Blade)
Adjust so that the blade protrudes slightly more than the media to be cut.
Set the cutting speed.
Reduce the speed when cutting fine or complex designs or thick media.
Set according to the thickness of the media to be cut.
Set the number of times to cut the design.
Increase the number of passes when cutting thick or hard media.
Thin materials, thin paper / films, and smooth iron-print materials
Medium thick paper (such as Kent paper), thick film, and flock iron-
print materials
Thick paper such as scrap-booking materials
Thick paper such as cardboard
Scale
Material types
03 About the Silhouette Studio Screen
48
Advertisement
Table of Contents
