Table of Contents
Advertisement
X7DB8+/X7DBE+ User's Manual
Compact Flash Master/Slave
Select
A Compact Flash Master (Primary)/Slave
(Secondary) Select Jumper is located
at JCF1. Close this jumper to enable
Compact Flash Card. For the Compact
Flash Card or the Compact Flash Jumper
(JCF1) to work properly, you will need to
connect the Compact Flash Card power
cable to JWF1 fi rst. Refer to the board
layout below for the location.
2
I
C Bus to PCI-X/PCI-Exp.
Slots
Jumpers J27, J28 allow you to connect
the System Management Bus (I
.
PCI-X/PCI-E slots
is "Open" to disable the connection.
See the table on the right for jumper
settings.
GLAN1
GLAN2
SIMLP IPMI
SEPC
PCI-Exp x8
PCI-Exp x4
C
B
2
C) to
The default setting
8-pin PWR
3rd PWR
PWR
Detect
Fault
PWRSMB
JAR
A
SCSI CTRL
320 SCSI Channel B
2-28
Compact Flash Card Master/
Slave Select
Jumper Defi nition
Open
Slave (Secondary)
Closed
Master (Primary)
I 2 C to PCI-S/PCI/Exp
Jumper Settings
Jumper Setting
Defi nition
Closed
Enabled
Open
Disabled (*Default)
FP Ctrl
A. Compact Flash Master/
Slave Select
Fan8
B. J27
C. J28
Advertisement
Table of Contents
