Compact Flash Master/Slave Enable/Disable; I 2 C Bus To Pci-X-Pci-E Slots - Supermicro X7DBN User Manual

Compact Flash Master/Slave
Select
A Compact Flash Master (Primary)/Slave
(Secondary) Select Jumper is located
at JCF1. Close this jumper to enable
Compact Flash Card. For the Compact
Flash Card or the Compact Flash Jumper
(JCF1) to work properly, you will need to
connect the Compact Flash Card power
cable to JWF1 fi rst. Refer to the board
layout below for the location.
I C Bus to PCI-X/PCI-Exp.
2
Slots
Jumpers J27, J28 allow you to connect
the System Management Bus (I
.
PCI-X/PCI-E slots The default setting
is "Open" to disable the connection.
See the table on the right for jumper
settings.
GLAN1
GLAN2
S IMLP IPMI
B S E PC
P C I-E xp x8
C
P C I-E xp x4
2
C) to
Jumper Setting
Closed
Open
S MB PS
PSF
J 3P
(CPUFan1)
J A R
A
2-27
Chapter 2: Installation
Compact Flash Card Master/
Slave Select
Jumper Defi nition
Open Slave (Secondary)
Closed Master (Primary)
I 2 C to PCI-S/PCI/Exp
Jumper Settings
Defi nition
Enabled
Disabled (*Default)
A. Compact Flash Master/
8-pin P W R
Slave Select
B.SMBus to PCI slots
(J27)
C.SMBus to PCI slots
(J28)
(CPUFan2)