Table of Contents
Advertisement
X7DB8/X7DBE User's Manual
Compact Flash Master/Slave
Select
A Compact Flash Master (Primary)/
Slave (Secondary) Select Jumper is
located at JCF1. Close this jumper to
enable Compact Flash Card. For the
Compact Flash Card or the Compact
Flash Jumper (JCF1) to work properly,
you will need to connect the Compact
Flash Card power cable to JWF1 fi rst.
Refer to the board layout below for the
location.
2
I
C Bus to PCI-X/PCI-Exp.
Slots
Jumpers J27, J28 allow you to connect
the System Management Bus (I
.
PCI-X/PCI-E slots
The default setting
is "Open" to disable the connection.
See the table on the right for jumper
settings.
GLAN1
GLAN2
SIMLP IPMI
SEPC
PCI-Exp x8
PCI-Exp x4
B
Compact Flash Card Master/
Jumper Defi nition
Open
Closed
Jumper Setting
Closed
2
C) to
Open
8-pin PWR
SMB PS
PSF
J3P
JAR
A
SCSI CTRL
320 SCSI Channel B
2-28
Slave Select
Slave (Secondary)
Master (Primary)
I 2 C to PCI-S/PCI/Exp
Jumper Settings
Defi nition
Enabled
Disabled (*Default)
A. Compact Flash Master/
Slave Select
B. SMBus to PCI slots
Advertisement
Table of Contents
