Remove The Thermal Module - Lenovo V14 Gen 2 Hardware Maintenance Manual

Figure 21. Remove the memory module
Go to https://support.lenovo.com/partslookup
replacement parts:
DIMM absorber
Memory module
Memory module shielding

Remove the thermal module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 34
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Loosen four screws and then release the antennas from the cable guides. Peel off the motherboard
mylar.
Note: The motherboard mylar is not reusable. Replace it when replacing related FRUs.
Figure 22. Loosen four screws and then release the antennas
Step 3. Remove three screws and then remove the thermal module.
42
Hardware Maintenance Manual
to look up the Lenovo part numbers of the following