Remove The Hard Disk Drive (Hdd) Module - Lenovo V14 Gen 2 Hardware Maintenance Manual

Hide thumbs Also See for V14 Gen 2:
Table of Contents

Advertisement

Screw specifications
M2 x L6
M2 x L4
Step 3.
Pry up the latches and then remove the lower case.
Figure 6. Pry up the latches and remove the lower case
Go to
https://support.lenovo.com/partslookup
part:
Lower case

Remove the hard disk drive (HDD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 34
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Figure 7. Disconnect the battery pack cable from the system board
Step 2.
Disconnect the HDD cable from the system board. Remove four screws and then remove the HDD
module.
Number of screws
6
4
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

V15 gen 2

Table of Contents