Table of Contents
Advertisement
Remove the thermal module
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 28
Step 1.
Disconnect the battery pack cable from the system board and peel off the thermal mylar.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 18. Disconnect battery pack cable and peel off thermal mylar
Step 2.
Disconnect the fan cable connector and remove the cable from fan hooks.
Figure 19. Disconnect the fan cable connector and remove the cable
Step 3.
Disconnect the fan cable. Then, loosen four screws in alphabetical order from the heat sink and
remove two screws from the fan. Then, remove the thermal module.
.
Chapter 4
Removing a FRU or CRU
37
Advertisement
Table of Contents
