Scsi Control Enable; Scsi Termination Enable/Disable - Supermicro X6DA8-G User Manual

SCSI Controller Enable/
Disable (*ForX6DA8-G/
X6DA8-G2 only)
Jumper JPA1 allows you to enable
or disable the SCSI headers.
default setting is pins 1-2 to enable
all four headers. See the table on
the right for jumper settings.
SCSI Termination Enable/
Disable (*ForX6DA8-G/
X6DA8-G2 only)
Jumpers JPA2 and JPA3 allow you
to enable or disable termination for
the SCSI connectors. Jumper JPA2
controls SCSI channel A and JPA3
is for SCSI channel B. The default
setting is open to enable (terminate)
both SCSI channels. (*Note: In or-
der for the SCSI drives to function
properly, please do not change the
default setting set by the manufac-
turer.) See the table on the right
for jumper settings.
4-pin A T X P W R
Fan6 Fan5 P W R
DIMM 1B
Bank 1
DIMM 1A Bank 1
DIMM 2B Bank 2
DIMM 2A Bank 2
DIMM 3B Bank 3
DIMM 3A
Bank 3
Bank 4
DIMM 4B
Bank 4
DIMM 4A
M i c
The
PW SMB
FAN7
Force
P W
CPU1
CPU2
IPMI 2.0
JBT1
BIOS
SCSI CTRL
E n a b l e
JPA1
7 9 0 2
S C S I
C T R L
SCSI Ch.A
Term.
FPUSB 6/7
SCSICh.B
SATA1
SATA0 SCSI Ch B
Term.
2-25
Chapter 2: Installation
SCSI Enable/Disable
Jumper Settings
Jumper
Position
Pins 1-2
Pins 2-3
SCSI Channel Termination
Enable/Disable
Jumper Settings
Jumper
Position
Open
Closed
12V 8-
P W p i n P W
Fault
(*X6DA8/
E-G2)
SCSI Enable
SCSI ChA/B
Term. Enable
(JPA1)
Definition
Enabled
Disabled
(JPA2, JPA3)
Definition
Enabled
Disabled