Table of Contents
Advertisement
6-2
Front Control Panel
The front control panel must be connected to the JF2 connector on the
motherboard to provide you with system status and alarm indications. A
ribbon cable has bundled these wires together to simplify this connection.
Connect the cable from JF2 on the motherboard (making sure the red wire
plugs into pin 1) to the appropriate comnnector on the front control panel
PCB (printed circuit board). Pull all excess cabling over to the control
panel side of the chassis. The LEDs inform you of system status - see
Figure 6-2 for details. Figure 6-3 shows the connections, jumpers and
indicators located on the front control panel PCB. See Chapter 5 for
details on JF2.
Power
HDD
NIC1
NIC2
Overheat
Power Fail
Figure 6-2. Front Control Panel LEDs
Indicates power is being supplied to the system.
Indicates IDE hard disk/CD-ROM drive activity.
Indicates network activity on LAN Port 1 (Mb LAN).
1
2
Indicates network activity on LAN Port 2 (Gb LAN).
Indicates an overheat condition in either one of the
processors.
Indicates a power supply failure.
Chapter 6: Advanced Chassis Setup
6-3
Advertisement
Table of Contents
