Table of Contents
Advertisement
Figure 6-3.
6-4
Drive Bay Installation
A bezel covers the front of the chassis but does not need to be removed
to access the SCSI drives. If you wish to remove the bezel piece, push
on the three tabs on the inside left side lip of the front chassis cover.
Then slightly swing out the same (left) side of the cover - about ½ inch
only. Remove by pushing on the open side of the cover to remove it
from the chassis (do not try to swing or pull it straight out after opening
the left side.
SCSI Drives
After unlocking the SCSI drive bay door swing it open to access the SCSI
drives. SCSI drive IDs are preconfigured as 0 through 6 in order from
bottom to top (or from left to right if rackmounted). Note: You must use
standard 1" high, 80-pin SCA SCSI drives in the SuperServer 7042M-6.
Use extreme caution when working around the SCSI
backplane.
!
metal objects and make sure no ribbon cables touch
the backplane or obstruct the airflow holes in the
SCSI backplane.
Chapter 6: Advanced Chassis Setup
Removing the 12-cm Exhaust Fan
Do not touch the backplane with any
6-5
Advertisement
Table of Contents
