Table of Contents
Advertisement
S
UPERSERVER 6022P-6 User's Manual
module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Memory Support
The P4DP6 only supports ECC registered PC1600 (200 MHz DDR-RAM)
memory.
PC2100 DDR-RAM is supported but only at 200 MHz (PC1600
speed). PC100/133 SDRAM is not supported.
See Figures 5-5a and 5-5b for installing and removing memory modules.
Figure 5-5a.
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notches.
To Remove: Use your thumbs to gently push each release tab outward
to free the DIMM from the slot.
Side View of DIMM Installation into Slot
Figure 5-5b.
Top View of DIMM Slot
5-8
Advertisement
Table of Contents
