Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• To identify small parts, see page 7.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
1. Make sure that
the power cord
is unplugged. Be
careful not to pinch
the power cord.
Slide the Upright Cover (not shown) off the
Upright (81).
Orient the Upright (81) and the plastic tie (A) as
shown. Set the Upright on the tabs (B) on the
Frame (53). Then, attach the Upright with four
3/8" x 3 1/4" Screws (1), two 3/8" Star Washers
(2), and two 3/8" Flat Washers (43); start all
four Screws, and then torque them to 20
pound-feet (27 Newton-meters). Do not pinch
any wires.
• Assembly requires the following tools:
one set of English hex keys
one adjustable wrench
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
2
1
1
43
8
A
81
53
B
Advertisement
Table of Contents
