Table of Contents
Advertisement
PREVENTIVE MAINTENANCE
Regular maintenance is necessary for optimal perfor-
mance and long life of the treadmill. Please read and
follow all instructions below. If you have questions, see
the back cover of this manual.
WARNING:
procedures are not performed as described,
components may wear excessively, the tread-
mill may become damaged, a risk of injury or
a risk of fire may result, and the warranty will
be voided.
WEEKLY MAINTENANCE
1. Remove the key and unplug the power cord.
Inspect and properly tighten all external parts of the
treadmill.
2. Apply a mild multi-purpose cleaner to a 100% cotton
cloth and remove any dust and grime from the hand-
rails, upright, foot rails, frame, and motor hood. In
addition, wipe the walking platform along the sides
of the walking belt; do not wipe under the walking
belt. Then, apply a small amount of the cleaner to
a second cloth and wipe the console and screen(s).
Do not spray cleaner directly onto the treadmill
or use ammonia or acid-based cleaners.
3. Vacuum the area around the treadmill.
4. Make sure that the walking belt is centered and
properly tightened. If it is centered and runs
smoothly when a person is running on the treadmill,
do not make any adjustments. If the walking belt
needs to be adjusted, see pages 27, 28, and 31.
If all maintenance
MONTHLY MAINTENANCE
1. Remove the key and unplug the power cord.
Next, remove the two indicated 5/16" x 1/2" Screws
(16), and lift off the Motor Hood (66).
1
66
16
2. Using a hand-
held vacuum,
clean the area
that was under
the motor hood.
Be careful to
avoid touching
any compo-
nents. Then,
check the Motor
Belt (57) for wear, cracks, dust buildup, and proper
tension. If the Motor Belt needs to be replaced, see
the back cover of this manual.
3. Lift the edge of the walking belt and slide your hand
between the walking belt and the walking board.
If the underside of the walking belt is dry, you may
need to apply more lubricant (see the back cover of
this manual).
4. Plug in the power cord and insert the key into the
console. Then, press the Quick Start button. Be
careful to avoid injury; keep your hands away
from moving parts and make sure that your
clothes cannot become caught in moving parts.
While the walking belt is moving, check the treadmill
for unusual noises or odors. If any of these prob-
lems exists, see the back cover of this manual.
Remove the key and unplug the power cord.
See step 1. Reattach the Motor Hood (66) with the
5/16" x 1/2" Screws (16).
25
2
57
Advertisement
Table of Contents
