Glan Enable/Disable; Vga Enable/Disable; Front Side Bus Speed; Serial Ata Enable/Disable - Supermicro SUPERSERVER 6013P-T User Manual

GLAN Enable/Disable

Change the setting of jumper JD4
to enable or disable the onboard
GLAN ports (GLAN1 and GLAN2)
on the serverboard. See the table
on the right for jumper settings.
The default setting is enabled

VGA Enable/Disable

JP4 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
See the table on the right for
jumper settings.

Front Side Bus Speed

JP38 is used to set the system
(front side) bus speed for the pro-
cessors. It is best to keep this
jumper set to Auto. This jumper is
used together with the CPU Ratio
Frequency setting in BIOS.
the table on the right for jumper
settings.

Serial ATA Enable/Disable

Jumpers JPS1 and JPS2 allow you
to enable or disable the Serial ATA
headers. Jumper JPS1 is for head-
ers SATA#0 and SATA#1 and
jumper JPS2 controls headers
SATA#2 and SATA#3. The default
setting is both jumpers on pins 1-2
to enable all four headers. See the
table on the right for jumper set-
tings.
Chapter 5: Advanced Serverboard Setup
See
Serial ATA Enable/Disable
Jumper
Position
Pins 1-2
Pins 2-3
5-19
GLAN
Enable/Disable
Jumper Settings
(JD4)
Jum per
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings
(JP4)
Jumper
Position Definition
1-2 Enabled
2-3 Disabled
Front Side Bus Speed
Jumper Settings (JP38)
Jumper
Position Definition
Pins 1-2 Auto
Pins 2-3 400 MHz
Open 533 Mhz
Jumper Settings
(JPS1/JPS2)
Definition
Enabled
Disabled