Standby Mode; Auto Restart; Rs-232C; Dhcp Client - Sharp TLM5200 Operation Manual

Menu operations
Reducing the start-up time

(Standby Mode)

You can reduce the monitor's start-up time after
turning on the power with the remote control.
Selectable
items
Mode1 Starting the monitor is quick from
standby.
Mode2 The RS-232C and Network functions
are activated even if the monitor is in
the standby mode.
Mode3 Power consumption is low while in
standby mode.
The RS-232C and Network functions
are switched off in standby mode.
Auto restart function

(Auto Restart)

Selectable
items
On If the power cord is unplugged from
the outlet or the breaker switch is
turned off when the monitor is on,
then the monitor automatically turns
on when the power cord is plugged
into the AC outlet or the breaker
switch is turned on.
Off The monitor does not turn on
automatically when the power cord
is plugged into the AC outlet or the
breaker switch is turned on.
Selecting the transmission speed

(RS-232C)

Make sure that both the monitor and computer are
set for the same baud rate.
Selectable
items
9600bps Transmission speed is slow.
115200bps Transmission speed is rapid.
38
Description
Description
Description
DHCP client setting

(DHCP Client)

Connect the LAN cable before turning the monitor
on. If not, the DHCP Client function does not work.
Selectable
Description
items
On Obtains confi guration parameters for
TCP/IP network automatically.
Off Sets the TCP/IP manually.
Select "On" for "DHCP Client". "Obtaining IP
Address..." appears, then the menu screen appears.
Confi rm the parameters of IP Address, Subnet Mask
and Gateway on the TCP/IP screen.
If the DHCP server is not available, "Could not
obtain IP Address." appears.
In this case, set the TCP/IP manually. (See below.)
TCP/IP setting

(TCP/IP)

Set the TCP/IP manually.
1
Select "Off" for "DHCP Client", then press
ENTER.
2
Select "TCP/IP", then press ENTER.
Enter "IP Address" using ▲/▼/◄/►, then press
3
ENTER.
MENU [Setup---TCP/IP]
IP Address 1 9 2. 1 68 . 15 0 . 00 2
Subnet Mask 2 5 5. 2 55 . 25 5 . 00 0
Gateway 0 0 0. 0 00 . 00 0 . 00 0
Enter "Subnet Mask" using ▲/▼/◄/►, then
4
press ENTER.
Enter "Gateway" using ▲/▼/◄/►, then press
5
ENTER.