Sharp TLM5200 Operation Manual page 52

Specifi cations
Power management
This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support
the same standard in order for the monitor's power management function to work.
DPMS: Display Power Management Signaling
DPMS Screen
consumption
ON STATE Display
No
STANDBY
display
DDC (plug and play)
The monitor supports the VESA DDC (Display Data Channel) standard.
DDC is a signal standard for plug and play between monitors and computers. Information about resolution
and other parameters is exchanged between the two. This function can be used if the computer supports
DDC and it has been configured to detect plug-and-play monitors.
There are several types of DDC, depending on the communication method used. This monitor supports
DDC2B.
Connecting pin assignments
DVI-D input terminal: DVI-D24 pin
RS-232C terminal: D-sub 9 pin
RGB/COMPONENT input terminal: mini D-sub 15 pin
50
Power
Hsync Vsync
312 W Yes Yes
7.5 W* No No
Pin No. Signal
1 T.M.D.S data 2-
2 T.M.D.S data 2+
3 T.M.D.S data 2/4 shield
4 Not connected
5 Not connected
6 DDC clock
7 DDC data
8 Not connected
9 T.M.D.S data 1-
10 T.M.D.S data 1+
11 T.M.D.S data 1/3 shield
12 Not connected
Pin No. Signal
1 Not connected
2 Received data
3 Transmitted data
4 Not connected
5 GND
Pin No. Signal
1 Video input (red)
2 Video input (green/sync on green)
3 Video input (blue)
4 Not connected
5 Not connected
6 Earth (red)
7 Earth (green/sync on green)
8 Earth (blue)
DMPM: Digital Monitor Power Management
DMPM Screen
Monitor ON Display
Active OFF No display
* When AUTO INPUT CHANGE is OFF. 11.5 W
when it is ON.
Pin No.
13 Not connected
14 +5 V power
15 GND
16 Hot plug detection
17 T.M.D.S data 0-
18 T.M.D.S data 0+
19 T.M.D.S data 0/5 shield
20 Not connected
21 Not connected
22 T.M.D.S clock shield
23 T.M.D.S clock+
24 T.M.D.S clock-
Pin No.
6 Not connected
7 Request to Send
8 Clear to Send
9 Not connected
Pin No.
9 +5 V power
10 GND
11 Not connected
12 DDC data
13 Horizontal sync signal: TTL level
14 Vertical sync signal: TTL level
15 DDC clock
Power
consumption
312 W
7.5 W*
Signal
Signal
Signal