Table of Contents
Advertisement
5
Installation
5.1
Notes on safety for the installation
After carefully cleaning all around the area where the burner is to
be installed, and arranging for the environment to be illuminated
correctly, proceed with the installation operations.
It is obligatory to carry out all installation,
maintenance and dismantling operations with the
electrical supply disconnected.
DANGER
5.2
Handling
The burner packaging includes a wooden platform, it is therefore
possible to handle the burner (still packaged) with a pallet truck
or fork lift truck.
Burner handling operations can be highly
dangerous if not carried out with the greatest
attention: distance unauthorised personnel, check
integrity and suitability of the means available.
ATTENTION
Check also that the area in which you are working
is empty and that there is an adequate escape
area (i.e. a free, safe area to which you can
quickly move if the burner should fall).
During handling, keep the load at no more than
20-25 cm from the ground.
5.3
Preliminary checks
Checking the consignment
After removing all the packaging, check the
integrity of the contents. In the event of doubt, do
not use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or
cardboard box, nails, clips, plastic bags, etc.)
must not be abandoned as they are potential
sources of danger and pollution; they should be
collected and disposed of in the appropriate
places.
Checking the characteristics of the burner
Check the identification label of the burner, showing:
the model (A) (Fig. 7) and type of burner (B);
the year of manufacture, in cryptographic form (C);
the serial number (D);
the data for electrical supply and the protection level (E);
the absorbed electrical power (F);
the types of fuel used and the relative supply pressures (G);
the possible minimum and maximum output data of the
burner (H) (see Firing rate).
Installation
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and
regulations of the laws in force.
ATTENTION
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
CAUTION
carefully clean all around the area where the
burner will be installed.
D
E
RIELLO S.p.A.
I−37045 Legnago (VR)
S8232
The burner output must be within the boiler's firing
rate.
ATTENTION
The label of a burner or any other component that
has been tampered with, removed or is missing
prevents the clear identification of the burner and
makes any installation or maintenance work
ATTENTION
difficult
13
GB
A
B
C
F
G
H
Fig. 7
20167399
Advertisement
Table of Contents
