Sharp AR-BC260 Operation Manual page 47

Problem
Smudges on printed Does a message appear indicating the
sheets. need for maintenance?
Color deviations When printing in color, character and color
occur. deviations appear.
The displayed paper
The display of the tray's paper size slide
size differs from the
differs from the paper size in the tray.
loaded paper size.
When printing on a
special size of The paper size setting is not set
paper, part of the correctly in the paper tray settings of the
printed image is custom settings.
missing.
When printing on a
special size of paper
using the bypass The paper size is not set correctly in the
tray, part of the special size settings for the bypass tray.
printed image is
missing.
Is
recommended paper being used?
Paper curled or damp?
Is the paper curled and does it
frequently
Paper misfeeds module/2 x 500 sheet paper drawer or
frequently. saddle stitch finisher?
Multiple
simultaneously?
Is
recommended paper being used?
Is paper size or weight out of the
allowable range?
Do wrinkles appear when printing
Printed paper is
envelopes?
wrinkled or the
image rubs off
Is the pressure adjustment lever of the
easily.
fusing unit out of position?
Paper damp?
The contrast on the
touch panel is too Is LCD contrast properly adjusted?
high or too low.
Check
paper other than
misfeed in the
sheets of paper
paper other than
Solution or cause
Please contact the your dealer as soon as
possible.
Perform color registration as explained on pages
12 and 13 of the key operator's guide.
When you change the paper size in the tray, be
sure to adjust the paper size slide on the tray to
the new paper size. (page 2-2)
When using a special size of paper, set the
correct paper size in millimeters in the paper tray
settings of the custom settings (see page 2-11). If
the paper size setting is not correct, part or all of
the image may not print (this depends on the
options installed).
When using a special size of paper, set the
correct paper size in millimeters as explained in
step 6 on page 2-12. If the paper size setting is
not correct, part or all of the image may not print
(this depends on the options installed).
SHARP-
Use SHARP-recommended paper.
Do not use curled or crimped paper. If you do not
use paper for a long time, store paper in the
wrapper in a dry location.
Paper may be curled when output depending on
duplex the paper type and quality.
In some cases turning the paper over in the tray
will reduce misfeeding due to curling.
fed
SHARP-
Use SHARP-recommended paper.
Use paper in the allowable range.
Moving the pressure adjusting levers of the
fusing unit from the normal position to a weaker
pressure position may help alleviate this
problem. (page 2-6)
Return the pressure adjusting levers of the
fusing unit to the normal position. (page 2-7)
Be sure to store paper in the wrapper in a dry
location and do not store paper in a location that is
Ghumid
Gat a high temperature or an extremely low
temperature.
Adjust the
CONTRAST" of custom settings. (page 2-13)
TROUBLESHOOTING
Remove the paper
from the paper tray
or the bypass tray,
fan the paper as
shown in
illustration,
then load it again.
contrast using "DISPLAY
2-25
2
the
and